Enter chinese/english word(s), Taiwan address or math. expression :

可輸入英文單字中文字詞台灣地址計算式 按[Enter]重新輸入
Network Working Group                                         P. Calhoun
Request for Comments: 5417                           Cisco Systems, Inc.
Category: Standards Track                                     March 2009

      Control And Provisioning of Wireless Access Points (CAPWAP)
                     Access Controller DHCP Option

Status of This Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (c) 2009 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents in effect on the date of
   publication of this document (http://trustee.ietf.org/license-info).
   Please review these documents carefully, as they describe your rights
   and restrictions with respect to this document.

   This document may contain material from IETF Documents or IETF
   Contributions published or made publicly available before November
   10, 2008.  The person(s) controlling the copyright in some of this
   material may not have granted the IETF Trust the right to allow
   modifications of such material outside the IETF Standards Process.
   Without obtaining an adequate license from the person(s) controlling
   the copyright in such materials, this document may not be modified
   outside the IETF Standards Process, and derivative works of it may
   not be created outside the IETF Standards Process, except to format
   it for publication as an RFC or to translate it into languages other
   than English.

Abstract

   The Control And Provisioning of Wireless Access Points Protocol
   allows a Wireless Termination Point to use DHCP to discover the
   Access Controllers to which it is to connect.  This document
   describes the DHCP options to be used by the CAPWAP Protocol.

Calhoun                     Standards Track                     [Page 1]
RFC 5417 CAPWAP AC DHCP Option March 2009 Table of Contents 1. Introduction ....................................................2 1.1. Conventions Used in This Document ..........................2 1.2. Terminology ................................................2 2. CAPWAP AC DHCPv4 Option .........................................2 3. CAPWAP AC DHCPv6 Option .........................................3 4. IANA Considerations .............................................5 5. Security Considerations .........................................5 6. Acknowledgments .................................................5 7. References ......................................................5 7.1. Normative References .......................................5 7.2. Informative References .....................................6 1. Introduction The Control And Provisioning of Wireless Access Points Protocol (CAPWAP) [RFC 5415] allows a Wireless Termination Point (WTP) to use DHCP to discover the Access Controllers (AC) to which it is to connect. Prior to the CAPWAP Discovery process, the WTP may use one of many methods to identify the proper AC with which to establish a CAPWAP connection. One of these methods is through the DHCP protocol. This is done through the CAPWAP AC DHCPv4 or CAPWAP AC DHCPv6 Option. 1.1. Conventions Used in This Document The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [RFC 2119]. 1.2. Terminology This document uses terminology defined in [RFC 3753], [RFC 2131], [RFC 3315], and [RFC 5415]. 2. CAPWAP AC DHCPv4 Option This section defines a DHCPv4 option that carries a list of 32-bit (binary) IPv4 addresses indicating one or more CAPWAP ACs available to the WTP. Calhoun Standards Track [Page 2]
RFC 5417 CAPWAP AC DHCP Option March 2009 The DHCPv4 option for CAPWAP has the format shown in the following figure: 0 1 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | option-code | option-length | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | | + AC IPv4 Address + | | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | ... | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ option-code: OPTION_CAPWAP_AC_V4 (138) option-length: Length of the 'options' field in octets; MUST be a multiple of four (4). AC IPv4 Address: IPv4 address of a CAPWAP AC that the WTP may use. The ACs are listed in the order of preference for use by the WTP. A DHCPv4 client, acting on behalf of a CAPWAP WTP, MUST request the CAPWAP AC DHCPv4 Option in a Parameter Request List Option, as described in [RFC 2131] and [RFC 2132]. A DHCPv4 server returns the CAPWAP AC Option to the client if the server policy is configured appropriately and the server is configured with a list of CAPWAP AC addresses. A CAPWAP WTP, acting as a DHCPv4 client, receiving the CAPWAP AC DHCPv4 Option MAY use the (list of) IP address(es) to locate an AC. The CAPWAP Protocol [RFC 5415] provides guidance on the WTP's discovery process. The WTP, acting as a DHCPv4 client, SHOULD try the records in the order listed in the CAPWAP AC DHCPv4 Option received from the DHCPv4 server. 3. CAPWAP AC DHCPv6 Option This section defines a DHCPv6 option that carries a list of 128-bit (binary) IPv6 addresses indicating one or more CAPWAP ACs available to the WTP. Calhoun Standards Track [Page 3]
RFC 5417 CAPWAP AC DHCP Option March 2009 The DHCPv6 option for CAPWAP has the format shown in the following figure: 0 1 2 3 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | option-code | option-length | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | | + + | | + AC IPv6 Address + | | + + | | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | .... | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ option-code: OPTION_CAPWAP_AC_V6 (52) option-length: Length of the 'options' field in octets; MUST be a multiple of sixteen (16). AC IPv6 Address: IPv6 address of a CAPWAP AC that the WTP may use. The ACs are listed in the order of preference for use by the WTP. A DHCPv6 client, acting on behalf of a CAPWAP WTP, MUST request the CAPWAP AC DHCPv6 Option in a Parameter Request List Option, as described in [RFC 3315]. A DHCPv6 server returns the CAPWAP AC Option to the client if the server policy is configured appropriately and the server is configured with a list of CAPWAP AC addresses. A CAPWAP WTP, acting as a DHCPv6 client, receiving the CAPWAP AC DHCPv6 Option MAY use the (list of) IP address(es) to locate an AC. The CAPWAP Protocol [RFC 5415] provides guidance on the WTP's discovery process. The WTP, acting as a DHCPv6 client, SHOULD try the records in the order listed in the CAPWAP AC DHCPv6 Option received from the DHCPv6 server. Calhoun Standards Track [Page 4]
RFC 5417 CAPWAP AC DHCP Option March 2009 4. IANA Considerations The following DHCPv4 option code for CAPWAP AC Options has been assigned by IANA: Option Name Value Described in ----------------------------------------------- OPTION_CAPWAP_AC_V4 138 Section 2 The following DHCPv6 option code for CAPWAP AC Options has been assigned by IANA: Option Name Value Described in ------------------------------------------------ OPTION_CAPWAP_AC_V6 52 Section 3 5. Security Considerations The security considerations in [RFC 2131], [RFC 2132], and [RFC 3315] apply. If an adversary manages to modify the response from a DHCP server or insert its own response, a WTP could be led to contact a rogue CAPWAP AC, possibly one that then intercepts call requests or denies service. CAPWAP's use of Datagram Transport Layer Security (DTLS) MUST be used to authenticate the CAPWAP peers in the establishment of the session. In most of the networks, the DHCP exchange that delivers the options prior to network access authentication is neither integrity protected nor origin authenticated. Therefore, in security sensitive environments, the options defined in this document SHOULD NOT be the only methods used to determine to which AC a WTP should connect. The CAPWAP protocol [RFC 5415] defines other AC discovery procedures a WTP MAY utilize. 6. Acknowledgments The following individuals are acknowledged for their contributions to this protocol specification: Ralph Droms, Margaret Wasserman. 7. References 7.1. Normative References [RFC 2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [RFC 2131] Droms, R., "Dynamic Host Configuration Protocol", RFC 2131, March 1997. Calhoun Standards Track [Page 5]
RFC 5417 CAPWAP AC DHCP Option March 2009 [RFC 2132] Alexander, S. and R. Droms, "DHCP Options and BOOTP Vendor Extensions", RFC 2132, March 1997. [RFC 3315] Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C., and M. Carney, "Dynamic Host Configuration Protocol for IPv6 (DHCPv6)", RFC 3315, July 2003. [RFC 5415] Montemurro, M., Stanley, D., and P. Calhoun, "CAPWAP Protocol Specification", RFC 5415, March 2009. 7.2. Informative References [RFC 3753] Manner, J. and M. Kojo, "Mobility Related Terminology", RFC 3753, June 2004. Author's Address Pat R. Calhoun Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134 Phone: +1 408-902-3240 EMail: pcalhoun@cisco.com Calhoun Standards Track [Page 6]